Cooktop type
Gas cooktop
Width (in.)
38 cm
Total number of cooktop burners
2
Power of the heating elements
1 x 2.0 KW, 1 x 4.0 KW
Basic surface material
brushed stainless steel
Frame type
Standard design
Variant color
Stainless steel
Energy efficiency of hob
58.5 %
Dimensions
158 x 380 x 520 mm
Minimum height for installation
134 mm
Maximum height for installation (in.)
134 mm
Minimum width for installation
359 mm
Maximum width for installation
361 mm
Depth for installation
491 mm
Previous Next Previous Next [{? it.layer }] [{?}] [{? it.layer }] [{?}]
Cooktop-based hood control
No
Watts
15 W
Gas connection rating
6,000 W
Fuse protection
15; 2 A
Volts
120 V
Power cord length
140 cm
Plug type
120V-3 prong
Gas type
Natural gas 15 mbar (USA)
Cooking zones 1 two-ring high output burner (570 - 13,600 BTU), suitable for pots up to max. 11".
1 two-ring standard output burner (570 - 6,800 BTU), suitable for pots up to max. 9 7/16".
Operation Control knobs with illuminated
ring, cooking zone and output level markings.
One-handed operation.
Full electronic control in 12 output levels for exact power level regulation plus simmer function.
Automatic quick ignition.
Features Simmer function.
Cast-iron pan support with flat, continuous pot surface.
Brass burner rings.
Safety Electronic flame monitoring with automatic re-ignition.
Residual heat indicator.
Safety shut-off.
Planning notes Depending on the type of installation - surface-/ or flush-mounted, with or without cover - the specific location of the control knob positions may vary.
If combining several Vario appliances of the 400 series, a connection strip VA 420 must be placed between the appliances. Depending on the type of installation, the corresponding connection strip must be provided.
The bearing capacity and stability,
in the case of thin countertops in particular, must be supported using suitable substructures. Take into account the appliance weight and additional loads.
Flush installation is possible in countertops made of stone, synthetics or solid wood. Heat resistance and watertight sealing of the edges must be observed. For other materials, please consult with your countertop manufacturer.
The groove must be continuous and even, so that uniform placing of the appliance on the gasket is ensured. Do not use discontinuous lining.
The joint width may vary due to size tolerances of the combinations and of the countertop cut-out.
If installing several appliances in individual cut-outs allow for a division bar of inimum 1 " (50 mm) between the individual cut-outs.
The adjacent drawing "Installation of the control knob" must be observed if the panel is more than 1" thick. There must be a recess at the rear for proper electronic knob installation.
Plan for an electrical connection (the appliance is not operable without power supply).
Air intake from above.
No intermediate shelf required.
The rear panel must consist of a non-flammable material. Wall trims must be resistant to heat.
The minimum distance from the side of appliance edge to the wall or furnishing components must be at least 6".
When used with VL 414 downdraft ventilation, the air deflector AA 414 is recommended to ensure maximum permance of the cooktop.
Minimum distance between gas cooktop(s) with more than 37,533 BTU (11kW) and ventilation hood must be 30" (76cm).
Appliance can be snapped into the worktop from above.
Rating Total Amps: 15 A.
120 V / 60 Hz.
Connecting cable 55" (1.4 m) with plug.
Show All Technical Information